Corrections For Power Outages; Using Usb Memory - Mitsubishi Heavy Industries SC-SL3NA-AE Manual Del Propietário

11. Press the "Valid" or "Invalid" button for the Individual Lock/Unlock. (Factory default : Invalid)
This enables or disables permitting and prohibiting the individual operation such as run/stop, mode and
temperature settings of the remote controller.
Note
This function can be applied to the indoor units, which are the model KXE4 or later, and to the remote
controller, which is the model RC-E1 or later.
12. Press the "Unlock" or "Lock" button for the Remote Controller's Timer. (Factory default : Unlock)
This permits or prohibits remote controller's timer operation for all the air conditioners defi ned in a group.
13. Press the SET button.
Press the Cancel button to cancel the change.
Note
Set the timeout of the backlight as short as possible in order to make the lifetime of LCD longer.

Corrections for Power Outages

Data maintained during a power outage
• System confi guration defi ned on Page 8
• Schedule settings made on Page 20
• Function setting made on Page 27
• Calculation data of power consumption until the power outage (SC-SL3NA-BE only)
Data not maintained during a power outage
• Operating conditions and preset status of each indoor unit before the power outage (including the operation
mode, set temperature, and preset status for permitting or prohibiting remote controller operation and etc.).
In case the blackout continues more than 48 hours, the clock inside will stop and the operation of each group
cannot follow any schedule settings. Please reset the clock.
In case the blackout continues less than 48 hours, you do not have to reset the clock, and each group will run/
stop according to the following rule.
When the power returns, the operation of each group will follow the closest schedule setting before the power returns.
In case there are no settings in the closest schedule setting, it will follow the second closest schedule setting.
In case there are no schedule settings on that day, this center console will not send any operation signal to each group.

Using USB Memory

Attention
• Be sure to use bundled USB memory.
• Be sure to perform these operations after inserting the USB memory into the unit.
• The calculating data for twelve months are saved. Please save it to a PC through the USB memory
within twelve months.
• Please do not operate while the display light of the USB memory is blinking fast.
You may perform your operations or remove the USB memory only when the display light is blinking
slowly.
If the USB memory you use does not have a red blinking light, please wait for a moment after each operation.
Remove the USB memory only after all operations have been completed.
<Transferring Monthly Data>
It is convenient if folders are created in the USB memory in advance.
1. Press IMPORT EXPORT button on the MAIN MENU.
[Import/Export screen]
Page 7
2
– 28 –
Page 4