Procedure For Requesting Service; Identification Of Manufacturer And Appliance - Angelo Po 10NCP1IA Manual De Uso

The nameplate shown here is fi tted directly
to the appliance. It contains references and all
essential information for operating safety.
Extra nameplate
A)
a 1 ) Country of use
a 2 ) Appliance category
a 3 ) Type of gas
a 4 ) Gas pressure
a 5 ) Type of fume exhaust vent
Nameplate
B)
b 1 ) Appliance model
b 2 ) Type of customisation
b 3 ) Manufacturer identifi cation
b 4 ) Serial number
b 5 ) Protection class
b 6 ) EC conformity mark
b 7 ) Reference standard
b 8 ) EC certifi cate number
b 9 ) Product family type
b 10 ) Type of gas
GB
For all requirements contact the agents or the
headquarters of Angelo Po which can be found
in the contacts section of the website http://
www.angelopo.com.
3329640_inst_GB

IDENTIFICATION OF MANUFACTURER AND APPLIANCE

PROCEDURE FOR REQUESTING SERVICE

b 11 ) Rated power (kW)
b 12 ) Gas consumption
b 13 ) Testing gas indicator frame
b 12,5 ) Voltage (V)
b 15 ) Frequency (Hz)
b 16 ) Electricity power consumption (W)
b 17 ) Test voltage indicator
b 18 ) Date of construction
Testing gas plate
C)
c 1 ) Type of gas
c 2 ) Gas pressure
The installer must select the plate (A)and apply it
alongside the nameplate relating to the country
of use, and must mark the relative appliance class
(Type A = standard fume exhaust vent).
If the appliance is to be used with the same type
of gas as used by the manufacturer for testing,
the installer has to remove the plate (C) and
apply the indicator
gas for use on the nameplate.
When requesting service, state the data provide
on the nameplate and provide a description of
the fault.
- 4 -
against the data of the
(b13)
ENGLISH