Cooking Temperature Setting; Time Setting - Angelo Po 10NCP1IA Manual De Uso

This procedure is used to set a temperature
threshold at which a buzzer is triggered.
Press the key (C) to start the heating phase
1)
and the display (A) will show the cooking
temperature.
Press the keys (G-H) to increase or decrease
2)
the values shown on the display.
Wait about 4 seconds for the new value set to
3)
be saved.
Press the keys (G-H) together and the display
will show the water temperature in the coo-
king well.
Manual cooking
Proceed as follows.
Press the key (D). The last value set appears
1)
on the display (A).
Press the keys (G-H) to increase or decrease
2)
the values shown on the display. The cooking
time increases or decreases by 30 seconds
each time one of the keys (G-H) is pressed.
Press the key (D) again to start the cooking
3)
cycle.
Programmed cooking
Proceed as follows.
Keep pressing the key (E) until the display
1)
(A) shows the cooking time required (up to 5
preset cooking times can be recalled).
Press key (D) to start the cooking cycle.
2)
Modify program
Proceed as follows.
Press the key (E) until the display (A) shows
1)
the cooking time you wish to modify.
Press the keys (G-H) to increase or decrease
2)
the values shown on the display. The cooking
time increases or decreases by 30 seconds
each time one of the keys (G-H) is pressed.
3329640_ut_GB

COOKING TEMPERATURE SETTING

TIME SETTING

- 11 -
A
C
G
Important
During the cooking cycle the value shown on
the display (A) fl ashes if the temperature of
the water in the well is less than that set, or
remains constantly on if the temperature is
at or above the set level.
A
C
G
Keep the key (E) pressed (about 5 seconds)
3)
until the buzzer sounds. The value on the
display will stop fl ashing.
Important
The value which was modifi ed is deleted
from the appliance's memory and the new
value set is saved.
Press key (D) to start the cooking cycle.
4)
H
H D
ENGLISH
E
GB