To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Pull off the knob (A).
2)
Unscrew the union (B).
3)
Remove the nozzle (C) and replace it with the
4)
one suitable for the type of gas in use (see
table at back of manual).
Screw the union (B) back into place and close
5)
the door(A) on completion of the operation.
REPLACEMENT OF PILOT LIGHT UNIT COMPONENTS (0*1FR1GD-1*1FR2GD)
To carry out this operation,
proceed as follows.
Turn off the gas supply
1)
tap.
Open the hatch (A).
2)
Unscrew the screws (B)
3)
to remove the guard (C).
Disconnect the gas sup-
4)
ply line (E).
Unscrew the thermocou-
5)
ple (D).
GB
Disconnect the cable (P)
6)
Undo the screws (F) and remove the pilot
7)
light unit (G).
Undo the screws (H) and replace the ignition
8)
plug (L) and/or the body of the pilot light (M)
and/or the thermocouple (D).
Reassemble the pilot light unit (G) and recon-
9)
nect the gas supply line (E), the thermocouple
(D) and the cable (P).
Replace the guard (C).
10)
Close the door (A) when the operation is
11)
complete.
3301390_inst_GB_rev.2
REPLACEMENT OF THE PILOT LIGHT INJECTOR
A
A
B
B
C
E F
F
- 16 -
E
D
D
G
H
P
B
ENGLISH
C
B
L