Extension Cords; Functional Description; Carton Contents - Delta 40-695 Manual De Instrucciones

EXTENSION CORdS

Use proper extension cords. Make
sure your extension cord is in good condition and is a
3-wire extension cord which has a 3-prong grounding
type plug and matching receptacle which will accept
the machine's plug. When using an extension cord, be
sure to use one heavy enough to carry the current of
the machine. An undersized cord will cause a drop in
line voltage, resulting in loss of power and overheating.
Fig. C, shows the correct gauge to use depending on
the cord length. If in doubt, use the next heavier gauge.
The smaller the gauge number, the heavier the cord.
FOREWORd
The DELTA 40-695 is a 20" (508 mm) variable speed scroll saw with a 1.3 amp motor with speeds ranging between 400
®
to 1750 RPM. The table provides a material hold-down and bevels 45° left or right.
NOTICE: The manual cover illustrates the current production model. All other illustrations contained in the manual are
representative only and may not depict the actual labeling or accessories included. These are intended to illustrate
technique only.
1
1. S croll Saw (Packed with table and blade unattached.)
2. Table mounting bolts (2)
3. Hex wrench
4. Work Light (40-692)
5. S tar wrench (1) (for removing and then re-installing
screws for work light)
6. Sheet metal stand parts (40-691)

FUNCTIONAL dESCRIPTION

CARTON CONTENTS

3
2
7
8
6
MINIMUM gAUgE EXTENSION CORd
RECOMMENDED SIZES FOR USE WITH STATIONARY ELECTRIC MACHINES
Total
Length of
Ampere
Cord in
Rating Volts Feet
0-6 120 up to 25
0-6 120 25-50
0-6 120 50-100
0-6 120 100-150
6-10 120 up to 25
6-10 120 25-50
6-10 120 50-100
6-10 120 100-150
10-12 120 up to 25
10-12 120 25-50
10-12 120 50-100
10-12 120 100-150
12-16 120 up to 25
12-16 120 25-50
12-16 120
GREATER THAN 50 FEET NOT RECOMMENDED
5
4
9
10
11
7. 5/16-18 x 1-1/2" (38.1 mm) carriage bolts (4)
8. 5 /16-18 x 5/8" (15.9 mm) carriage bolts (22)
9. 5/16" Washers (26)
10. 5/16" Lock washers (26)
11. 5/16-18 Nuts (26)
gauge of Extension
Cord
18 AWg
16 AWg
16 AWg
14 AWg
18 AWg
16 AWg
14 AWg
12 AWg
16 AWg
16 AWg
14 AWg
12 AWg
14 AWg
12 AWg
Fig. C
6