Inspect the thread- jaws, pipe cutter and internal deburrer for any wear and replace parts if
there is wear.
Clean the clamping jaws with a wire brush if they are dirty.
Check that the dowel screws are secure. Tighten if necessary.
Remove dirt and chips from the machine regularly.
Apply anti-rust grease if the machine is not going to be used for an extended period.
Check the central lubricating system (see chapter 6.1)
7
Disposal
7.1
Metal, electrical and electronic parts
Parts of the unit are valuable materials and can be recycled. Approved and certified recycling
companies exist for this purpose. Metals must be sorted and delivered separately to a disposal
company.
Please consult your responsible refuse disposal authority for how to dispose of unusable parts in
an environmentally responsible way (e.g. electronic scrap):
For EU countries only:
Do not dispose of electric tools with domestic waste. In accordance with European
Directive 2002/96/EC on waste electrical and electronic equipment and its
implementation as national law, electric tools that are no longer serviceable must be
collected separately and utilised for environmentally compatible recycling.
7.2
Oils and lubricants
Only specialist companies are authorised to dispose of old oils.
Old oils and contaminated oils must be stored and disposed of in sealed, oil-resistant containers
(metal drums).
Defective electrical appliances and machines that cannot be repaired must be opened and
cleaned to remove the remaining oil.
Oil troughs must be cleaned so that there are no traces of oil. No oils (even very small amounts)
may be allowed to enter the ground
7.3
Waste from maintenance work
Regulations issued by the responsible national and regional authorities for disposing of refuse
must be observed. These are available from the local environmental authority.
If in doubt, waste from maintenance work such as cleaning and rinsing agents, cloths etc. must
be disposed of as special category waste by communal collecting points.
Waste that can be recycled must be separated on the basis of material groups and sent for
suitable recycling!
8
Customer service
The Rothenberger service locations or else the manufacturer with his repair department are
available to help you. Needless to say, we will also send you spare parts at short notice. Please
contact please your retailer or the manufacturer.
Order your accessories and spare parts from your specialist retailer or using our after-sales hotline:
Phone:
+49 (0) 6195 99 52 14
ENGLISH
Fax:
+49 (0) 6195 99 52 15
33