Legal Information - Ottobock 4R140 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 11
4 Fabrication
Use the attached nails to affix the 5X116 Dummy to the plaster positive (Fig. 2).
Afterwards laminate the socket in the usual way. Drill a hole (Ø 10 mm ) in
the center of the Dummy area. Apply silicone bonding agent (617H46) to
the threaded part of the 5X115 One-Way Valve (Fig. 3) and press into the
bore hole. Seal from outside with 617H46 silicone bonding agent (Fig. 4).
Next, screw the 607S37=M10 securing washer and the 502Z24=M10 knurled
nut onto the threaded part of the valve (Fig. 5 and 6).
Finally, let the silicone bonding agent dry for about 1 hour. Insert, from inside,
a 5X118 dust filter into the hexagon socket of the valve (Fig.7).
In case of Botta cosmetic covers or cosmetic covers coated with Superskin
the 502Z24=M10 knurled nut can be sealed in place on the socket.
Attention: Make sure that the 5X115 One-Way Valve does not come
in contact with resin.
If it is necessary to change the valve, unscrew it from the socket using a
4 mm allen wrench.

5 Legal information

All legal conditions are subject to the respective national laws of the country
of use and may vary accordingly.
5.1 Liability
The manufacturer will only assume liability if the product is used in accor-
dance with the descriptions and instructions provided in this document. The
manufacturer will not assume liability for damage caused by disregard of
this document, particularly due to improper use or unauthorised modification
of the product.
5.2 CE conformity
The product meets the requirements of Regulation (EU) 2017/745on me-
dical devices. The CE declaration of conformity can be downloaded from
the manufacturer's website.
6 | Ottobock

Publicidad

Tabla de contenido
loading

Tabla de contenido