Intended Use - Fulbat FULLOAD F4 Manual De Instrucciones

INTRODUCTION
Thank you for your purchase, please read these instructions they contain important information concerning safety, use
and disposal. Before using the product, please familiarize yourself with all of the safety information and instructions.
Only use the unit as described and for the specified applications. If you pass the product on to anyone else, please
ensure that you also pass on these instructions with it as well.

INTENDED USE

This model is multistep battery charger (called "charger" in the following) used for charging and float charge of 6V or
12V lead batteries (in the following called battery). These may be the types AGM-CA/CA-GEL-MF-VRLA with
electrolyte solution or GEL.
The manufacture/reseller is not liable for damage caused by improper use. The device is not intended for commercial
use, only be used indoors or away from direct weather or water exposure.
INTENDED INSIDE
1 Charger; 2 Clamps (1 red, 1 black); 1 Instructions for use
See Figure A
1. 12V 0.8A-(Program 2)
2. 12V 3.8A-(Program 3)
3. 12V 3.8A-(Program 4)
4. 6V 0.8A-(Program 1)
5. LED reverse connection
6. LED Stand-By
7. Charge Display
8. Condition Display
9. Voltage Display
10. ProgramSelection Button (MODE)
See Figure B
11. Charger
12. Fastening Eyelets
13. Main Lead
14. "+" pole clamp RED
15. "-" pole clamp BLACK
16. "+" pole connector cable RED
17. "-" pole connector cable BLACK
Tension
(V)
Current
(A)
Initial Rejuvenation
diagnostic
and Reverse
polarity
protection
test
Figure A
Figure B
Soft Start
Charge –
Battery
Rescue
8 stages
Bulk Charge Absorption
with high Charge –
current – up to 100%
up to 80%
Monitoring Demand
Recharging
Long term
Maintenanc
e
2