Yakima LoadWarrior Manual De Instrucciones página 2

•If you have fIxed bars:
If you have "Q TowerS"
oR bARs ThAT cAnnoT move...
continue to sTeP
never reposITIon The Q Towers!
Remove the machine screws from
the ends of the Loadwarrior tubes.
noTe: always replace
machine screws
with washers (from
loadWarrior) into same
holes when reassembling.
aTTach faIrIng To eITher end of baSkeT.
Pry open the
SnapArounds,
attach them
to the LOwER
FRONT BAR.
Load baSkeT onTo rackS.
center basket over your rack's crossbars.
1031908E-2/8
.
Q Tower owners:
exTensIon
UseRs:
You may find tapered
screws with your
Extension.
do noT insert the tapered
screws from extension into your
Loadwarrior's holes.
• Insert bolts through
washers, fairing
and Snaparounds.
• attach knobs and TIghTen.
A friend
would make
do not attach brackets at these locations.
this easier .
•If your bars Move:
If yoU hAve bARs ThAT cAn be moved...
Move the bars to 30" (76cm) apart.
TIghTen your crossbars
If you loosened TheM.
Assemble
The baSkeT.
MACHINE TAPERED
SCREwS SCREwS
do noT ATTAch bRAcKeTs
To unSTabLe PoInTS.
(SIDE vIEw)
Insert screws with
washers into each
of the joints and
tighten them.
NOTE: The fairing can fold down when
carrying long slender loads.