Replacing The Lamp - Zanussi ZOP38903XD Manual De Instrucciones

Open the door fully
1
and hold the two
door hinges.
Close the oven door
3
halfway to the first
opening position.
Then pull forward and
remove the door from
its seat.
2
B
Hold the door trim (B) on the top edge of the
door at the two sides and push inwards to
release the clip seal. Pull the door trim to the
front to remove it.
Hold the door glass panels by their top edge
and carefully pull them out one by one. Start
20
Lift and turn the
2
levers on the two
hinges.
Put the door on a soft
4
cloth on a stable
surface.
1
from the top panel. Make sure the glass slides
out of the supports completely.
Clean the glass panels with water and soap.
Dry the glass panels carefully.
When the cleaning is completed, install the
glass panels and the oven door. Do the above
steps in the opposite sequence.
Make sure that you put the glass panels (A, B
and C) back in the correct sequence. The
middle panel (B) has a decorative frame. The
screen-printing zone must face the inner side of
the door. Make sure that after the installation
the surface of the glass panel frame (B) on the
screen-printing zones is not rough when you
touch it.
A B
C
Make sure that you install the middle panel of
glass in the seats correctly.

Replacing the lamp

Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
A
B
C
www.zanussi.com