Troubleshooting - Zanussi ZOP38903XD Manual De Instrucciones

WARNING!
Danger of electrocution! Disconnect
the fuse before you replace the
lamp.
The lamp and the lamp glass cover
can be hot.
CAUTION!
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.

Troubleshooting

WARNING!
Refer to Safety chapters.
What to do if...
Problem
You cannot activate or operate
the oven.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The oven does not heat up. The
fan does not operate. The display
shows or .
www.zanussi.com
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
The back lamp
1. Turn the lamp glass cover counterclockwise
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
4. Install the glass cover.
Possible cause
The oven is not connected to an
electrical supply or it is connec-
ted incorrectly.
The oven is deactivated.
The clock is not set.
The necessary settings are not
set.
The automatic switch-off is acti-
vated.
The Child Lock is on.
The fuse is blown.
The lamp is defective.
The demo mode is activated.
deactivate the circuit breaker.
to remove it.
heat-resistant lamp.
Check if the oven is correctly
connected to the electrical sup-
ply (refer to the connection dia-
gram if available).
Activate the oven.
Set the clock.
Make sure that the settings are
correct.
Refer to "Automatic switch-off".
Refer to "Using the Child Lock".
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Replace the lamp.
1. Deactivate the oven.
2. Press and hold
appliance activates and re-
turn to the standby mode.
3. Press and hold
the same time until the
acoustic signal sounds again
and the indicator goes out.
Remedy
until the
and at
21