Function Keys - ProMinent DULCOMETER Pt 1000 Instrucciones De Servicio

Function Description
5.2
There are three function keys on the meter. The operations performed by each
key are described below
5.2.1
before
Measure pH
Measure Pt 1000
Measure redox
CAL pH
SIM pH
SIM redox
Manual
temperatur
compensation
32

Function keys

Function key "pH/mV/°C"
Operating state
subsequent
Measure
Pt 1000
Measure
redox
Measure
redox
Measure pH
After display-
ing the current
calibrating
data:
Measure pH
or
Measure
redox
Measure pH,
Measure
redox
Measure pH
Description
Pt 1000 probe is connected: switches
from pH measurement to temperature
measurement.
Pt 1000 probe is not connected: switches
from pH measurement to Redox
measurement.
Switches from temperature measurement
to Redox measurement.
Switches from redox measurement to pH
measurement.
1. Finishes the calibrating mode at any
point and displays the unchanged
calibrating data (zero point and slope)
2. Finishes the calibration as 1-point
calibration after the valid calibration
of P1. If applicable, new calibrating
data are calculated and displayed as
above.
• LCD marker "∆pH" is activated
and the zero point is displayed for
2 seconds
• LCD marker "%" is activated and the
slope is displayed for 2 seconds,
• meter changes to the previously set
measuring mode. If measure Pt 1000
was set before, measure pH will be
selected.
finishes the simulation mode and enters
the given measuring mode.
®
ProMinent