Mains Connection - BH FITNESS H855 Instrucciones De Montaje

8 FITTING THE MONITOR
Get the monitor (9), (Fig 9) and
connect speed sensor cable (11) with
cable (12).
terminal (10)
Finally, introduce the monitor in the
main body (A), firts the lower side and
then the upper side.
9 ADJUSTING SADDLE BACK
Place cup 31 in the upper hole on the
saddle back tube end as indicated in
Fig 13. To move the saddle back,
push button B (Fig 13), move it
forward or backwards until it is located
on the desired position and release
the button. Verify that the saddle back
is perfectly secured in one of the three
possible positions.
10 LEVELLING.
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This
can be achieved by screwing the
adjustable feet (E) up or down, as
shown in (Fig 10).
11 EXERTION SETTINGS.
(Mod. H-855). To provide an even
level of exertion during exercise, this
appliance is
tensioning control
various exertion settings (Fig. 7).
To increase pedal resistance turn the
tensioning control (100) clockwise (+)
Afterwards connect
with terminal
equipped with
(100), offering
until the exertion level best suits your
exercise requirements. To reduce
pedal resistance turn the tensioning
control (100) anticlockwise (-).
(13).
12 MOVEMENT & STORAGE
The unit is equipped with wheels (40)
to make it easier to move. The wheels
located at the front of your unit make it
easier to move it into a chosen
position, by lifting the rear of the unit
up slightly and pushing it, as shown in
(Fig 11). Store your unit in a dry place,
preferably not subject to changes in
temperature.
13

MAINS CONNECTION

(Mod H-856)
Insert the jack (g) on the transformer
(c) into the connection hole (h) on the
main body (A) (bottom, rear of the
machine)
transformer into a 220 V mains supply,
(Fig 12).
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
Do not hesitate to get touch with us if
a
you have any queries, by calling:
0844 335 3988 service@bh-uk.co.uk
12
and then plug the