Fitting The Handlebar - BH FITNESS H855 Instrucciones De Montaje

1.(1) Main body; (5) Handlebar; (27)
Saddle back; (29) Saddle; (9) Monitor;
(19) Rear stabiliser bar; (2) Front
stabiliser bar; (15) Right pedal marked
with letter (R); (16) Left pedal marked
with letter (L), (18) Rear stabilizer
support; a box
following: (4) Slot head bolts M-10; (3)
Plain washer M-10; (6) Handlebar
bracket (7) Open spring washer;
(24) Saddle support cover; (42) Allen
screw M6; (43) Allen key M5; (39) rear
trim ; (40) Double ended ring spanner;
(41) Pedal spanner.
2 Take the front stabiliser
wheels (2) and position it so that the
two red dots (A) line up, as shown in
Fig (2), insert bolts (4), fit the plain
washers (3), and tighten securely.
3

FITTING THE HANDLEBAR

Carefully insert
position indicated in Fig2 through the
lateral hole on the chain cover, as
marked with an arrow. Once introduced
turn it 180º untill tha handlebar leans
on the structure. Place the bracket (6),
put the screw (8) and the washer (7)
and tighten strongly.
4 FITTING THE SADDLE PROFILE
Firstly (Fig 3), place the saddle profile
(14) close to the main chain cover (1)
and connect
terminal (17) from saddle profile (14).
Afterwards introduce tube of main
body in aluminium profile, paying
special attention to the cables. Finally,
place screw (4) and washer (3) and
tighten securely.
5 FITTING THE REAR SUPPORT
Take the rear stabiliser bar (19) and
position it on the machine's rear stand
containing
bar with
handlebar (5)
terminal (12)
bracket support (18), as shown in (Fig.
4), inserts bolts (4), fit the plain
washers (3) and tighten securely.
Get rear support (18) with rear
stabilizer mounted and place it in the
aluminium profile as indicated in (Fig
the 5). Tighten strongly nuts (J) to screws
(C). Fit the rear trim (39).
(8)
6 ATTACHING THE SADDLE
Place saddle back support tube to the
upright position (Fig6). Get screw (25)
and place it in the metallic support
piece. Place washer and nut and
tighten securely.
Afterwards, unscrew the screws (28)
on the back side of the saddle back,
place it as shown in (Fig 7) and tighten
back again the screws securely.
7 FITTING THE PEDALS
The assembly instructions for the
in
pedals must be followed to the letter,
fitting these incorrectly could damage
the screw thread on either the pedal or
the crank.
Right and left refer to the position that
the user adopts when sitting on the
saddle to do the exercises.
The right-hand pedal (16), marked with
the letter (R), screws onto the right-
hand crank, also marked with an (R), in
a clockwise direction. Tighten securely,
(Fig. 8).
with
The left-hand pedal (15), marked with
the letter (L), screws onto the left-hand
crank, also marked with an (L), in an
anti-clockwise
securely, (fig 8).
Once the pedals have been fitted,
insert the end of the pedal clip (1) into
the slot on the pedal (2) adjusting it to
your footwear on the ledge of the
pedal (3), (Fig. 9A).
11
direction. Tighten