Inglesina easy clip Manual De Instrucciones página 16

EN
16
12 Push the wheel (B) towards inside and release
the hook (H) until hearing a click indicating that it has
hooked properly.
13 WARNING! Verify that the wheel is properly
hooked pulling it towards outside. Repeat the
same procedure also for the other front wheel.
14 Make sure that the chassis has been properly
assembled according to the figure.
HOW TO ENABLE/DISABLE THE BRAKE
15 To enable the brake push the bar (G)
downwards with the foot. To assure the safety of
your child, always enable the brake during any stop,
making sure the brake has actually been enabled.
16 To disable the brake lift the bar (G), pushing it
upwards with the foot.
HOOKING/RELEASE OF ADDITIONAL TRANSPORT
UNITS TO/FROM THE CHASSIS (CARRYCOT,
TRANSPORT SEAT AND CAR SEAT)
17 It is possible to hook to the chassis the
carrycot, the transport seat or the Huggy car seat.
For information on the correct hooking and release
operations, see the dedicated instructions manuals.
WARNING: Before proceeding with the hooking
and/or release operations, make sure that the
chassis is properly assembled and the brake duly
enabled. Before use, always verify the correct
hooking of the carrycot/transport seat/car seat to
the chassis.
HOW TO DISASSEMBLE THE BASKET
18 Lift the basket (M) end and remove it from the
chassis.
SPACE SAVING POSITION
In order to reduce the overall dimensions of the
chassis, the handle (D) can rotate forwards.
19 Only for ERGO BIKE version: press both push-
buttons (F) of the handle and rotate it towards inside,
according to the figure.
20 With braked chassis (see fig. 16), lift the safety
lever (N).
21 Pull the closing devices (E) towards outside.
22 Push the handle (D) forwards and let it rotate till
it reaches the position shown in figure.
HOW TO CLOSE THE CHASSIS
With braked chassis (see fig. 15), unhook any
additional transport units (see fig. 17).
23 Remove the front wheels (B) lifting the hooks
(H) and extracting the wheels from the related pins
(I).
INSTRUCTIONS
24 Lift the brake bar (G) (see fig. 15). Remove the
rear wheels (C) lifting the hooks (H) and extracting
the wheels from the related pins (I).
25 Close the handle rotating it as described in the
previous paragraph "SPACE SAVING POSITION".