Empty The Collector Bin; Filter Package; Spare Parts - Nederman FlexPAK 800 Manual De Instrucciones

EN FlexPAK 800/1000
NOTE! The unit is CE-marked. Connections to the unit, initial start-up and maintenance are
to be carried out according with this manual.
9.1

Empty the collector bin

WARNING!
Never use the unit without a plastic bag.
WARNING!
• Ensure that there is no vacuum in the dust separator before removing the collector bin.
• Crush hazard. Be careful when lowering and refitting the collector bin. Use proper
protective equipment.
• Wear goggles, dust mask and gloves when emptying the collector bin.
CAUTION!
Use only Nederman original spare parts and accessories.
NOTE! The plastic bag is to be replaced when filled up to 2/3, see figure 11.
To replace the plastic bag:
1. Check that the risk area is clear.
2. Ensure that there is no vacuum in the dust separator.
3.
Remove the collector bin.
4.
Seal and remove the plastic bag. Use a cable tie or equivalent, see figure 12.
5.
Fit a new plastic bag in the collector bin.
6.
Refit the collector bin onto the dust separator.
7. Check that the pressure equalizer hose is attached to the collector bin, see figure 14.
8. Check that the collector bin seals properly once vacuum is re-applied to the dust
separator.
9.2

Filter package

NOTE! Fitting the steel ring correctly is important to maintain the tightness and durability
of the unit.
Filter replacement is to be noted in the service protocol of the unit. Replacing individual
filter bags is possible, but it is recommended that the whole filter package is replaced since
it is quicker and causes less spreading of dust. The work is easy, if the unit is placed so it can
be tilted, see Figure 15. Also, the filter may be lifted straight up, see Figure 16, with a crane
or other lifting device.
If the filter bags are replaced separately, the plastic holders will also have to be replaced.
Figure 17, items A–C, shows how the rubber sealing rings are to be fitted. When a used
sealing ring is to be re-used, the form when open may differ from the original form as
shown in item A. Use a screwdriver to bring the edge of the module between the rubber
lips to obtain the result shown in item C.
9.3

Spare parts

CAUTION!
Use only Nederman original spare parts and accessories.
32
Explosion risk.
Risk of personal injury.
Risk of equipment damage.
Risk of equipment damage.