baltur GI 500 DSPGN ME Manual De Instrucciones página 32

DIAGRAM ILLUSTRATING REGULATION OF COMBUSTION HEAD AND DISTANCE
OF ELECTRODE DISK
E
N
G
L
I
S
H
1 - Ionizing electrode
2 - Ignition electrode
3 - Flame disk
4 - Mixer
5 - Gas delivery pipe
MAINTENANCE
Periodically analyse combustion gases and check emissions va-
lues.
Periodically replace the gas filter, whenever it is dirty.
Check that all components of the combustion head are in good
condition, have not been deformed by high temperatures and con-
tain no impurities or deposits from the installation environment or
from poor combustion; check the efficiency of electrodes. If it is
necessary to clean the outside of the combustion head, take out its
components according to the procedure described below:
- unscrew the four anchoring screws (N), and open the ventilating
body;
- pull out the ignition and ionization cables(I) from their electrode
terminals (L);
6 - Gas entry
7 - Burner connection flange
8 - Combustion head adjustment knob
Move forward to open passage of air between disk and
diffuser. Move back to close.
12 / 14
0006081225_200912
N° 0002935990
A B
MOD.
9 12
GI 500 DSPGN ME
GI 700 DSPGN ME 9 12
9 12
GI 850 DSPGN ME
X
19÷59
19÷59
8÷68