Culligan US-2 Instrucciones De Instalacion Y Uso página 7

11
INLET
Determine the length of 1/4˝ plastic tubing
needed to connect the system head inlet to the
water supply adapter (reference image above
for inlet and outlet location). Make sure to allow
enough plastic tubing to prevent kinking in
the line.
Cut the 1/4˝ plastic tubing squarely on both ends
with a utility knife, making sure not to crimp the
plastic tubing during cutting.
13
COLLAR
NOTE: Routine maintenance and cartridge
replacement will not require that you disconnect
the tubing from the system head; however, tubing
may be quickly and easily removed from the
fitting if necessary. First, turn off the water supply
to the filter. Open kitchen faucet, then press in
the grey collar around the fitting while pulling the
tubing with your other hand.
12
OUTLET
Wet one end of the 1/4˝ plastic tubing with
water and push it into the water supply adapter
approximately 5/8˝ until it stops.
Wet the other end of the 1/4˝ plastic tubing with
water and push it into the system head inlet
approximately 5/8˝ until it stops.
NOTE: Do not bend or crimp 1/4˝ plastic tubing
when inserting.
14
Determine the length of 1/4˝ plastic tubing
(attached to the faucet) needed to connect the
threaded faucet stem to the system head outlet.
Make sure to allow enough plastic tubing to
prevent kinking in the line.
Cut the 1/4˝ plastic tubing squarely on both ends
with a utility knife, making sure not to crimp the
plastic tubing during cutting.
7