Control Panel Description; Description Of Signals On Display - Pentair STA-RITE CPS3-10 Serie Manual De Instrucciones

EN
CHAPTER 5
PROGRAMMING
5.1 DESCRIZIONE DEL PANNELLO DI CONTROLLO
The control panel is shown in picture below.

5.2 DESCRIPTION OF SIGNALS ON DISPLAY

When running normally (that is, in the absence of any alarms) press the MODE button to alternate the available displays:
1. BAR/PSI - System pressure
•
Current pressure, shown in large
numbers on the display
•
Currently active set point (set 1 or set
2), shown in small numbers on the
display
•
Symbol of the type of control
•
Pressure unit of measurement (bar
or PSI)
2. Hz - Motor frequency
•
Current frequency of the pump in Hz
•
Frequency graph indicator
30
•
Frequency graph indicator
•
Indication of the Master (P) or Slave (S)
status only in group configuration
•
Message of the absence of the SLNS
sensor only for the Slave in group
configuration
•
Visualization of the configuration
address of the "Inn" group
•
Measurement unit
•
Indication: Day/Hour/Pressure/Alarms/
Faults/Advanced parameters
Frequency/Current/State of the pump.
•
Indication of access to settings.
•
Unit of measure of the displayed
parameter.
•
Temperature alarm indication.
•
Address module (Primary/Secondary).
•
START/STOP/Reset key.
•
Key to confirm the changes made.
•
Key for cancelling the changes made
during setup.
•
Parameters change push buttons.
•
Display change pushbutton.
•
Control type display icon.
•
Indication of displayed SET-POINT.
•
Operation LED (green)
Alarm/Fault (red).
•
Line LED green.
•
Graphic display of the frequency
supplied to the motor.