X-LITE X 502 Ultra Puro Seguridad E Instrucciones página 17

4. Peak Assembly
Check that the air intakes are properly hooked to the peak as they were originally
(Fig. 2B).
4.1. Place the trim of the upper central cover plate "A" in line with the threaded
hole and place the peak on the shell. Insert the upper central threaded cover
plate "A" into the hole and fasten by rotating it clockwise without tightening it
completely (Fig. 3).
4.2. Insert the left side cover plate "B" into the relevant seat on the shell and tighten
it completely (Fig. 3). Repeat the same operation on the other side of the hel-
met.
4.3. Complete the adjustment of the position of the peak and its extension as pre-
viously described (see steps 1.2., 1.3. and 2.).
WARNING
- Check that the cover plates, internal trim and air intakes, which are interposed
between the peak and the helmet shell, keep the peak steady in the desired
position.
- Do not use the helmet if the peak and peak extension have not been assem-
bled and adjusted properly.
- Do not install the peak without the internal trim of the cover plates and air
intakes.
- In case of malfunctioning or damages, please contact an authorized X-Lite
dealer.
REMOVABLE INNER COMFORT PADDING
The removable comfort padding consists of a liner, pads of the side cheek pads (right
and left) and covering straps, all completely removable and washable. The cheek
pads are also characterised by removable inner expanding foam padding.
5. Cheek Pad Disassembly
5.1. Unfasten the chin strap (see instructions).
5.2. Gently pull the red strap in the front area of the pad of the left cheek pad to
release the safety lever on its back (Fig. 4).
5.3. Hold the front part of the pad of the left cheek pad and turn it upwards to un-
hook the front and upper hooks on its back (Fig. 5).
5.4. Pull the back of the pad of the left cheek pad towards the inside of the helmet
to undo the snap fastener on its back (Fig. 6).
5.5. Pull brackets "A" and "B" of the pad of the left cheek pad upwards to unhook
them from the corresponding plates between the outer shell and polystyrene
cheek pad (Fig. 7).
5.6. Completely remove the pad of the left cheek pad from the helmet.
5.7. Repeat these steps with the right cheek pad.
Note: Do not remove the polystyrene cheek pads from the helmet shell.
17