Connection Of The Control; Digital Inputs; Analog Inputs; Outputs - KEB COMBIVERT F4-S Manual De Instrucciones

1.1.2 Connection of the
Control

1.1.3 Digital Inputs

1.1.4 Analog Inputs

Connect unused analog
inputs to common, to prevent
set value fluctuations!

1.1.5 Outputs

In order to prevent undefined
conditions during external
power supply, the external
power supply should be
switched on first and then the
inverter.
When using
consumers at the relay output a
protective wiring (i.e. free
wheeling diode) is necessary to
protect the relay!
Installation and Connection
In order to prevent a malfunction caused by interference voltage supply
on the control inputs, the following directions should be observed:
- Use shielded/drilled cables
- Lay shield on one side of the inverter onto earth potential
- Lay control and power cable separately (about 10...20 cm apart)
- Lay crossings in a right angle (in case it cannot be prevented)
EMC
4 5
13...30V DC
±0%smoothed
Ri =4,4 kΩ
4 5
Analog set-point
setting (see CP.24)
16 17 18
250V AC / 0,2 mA
30V DC / 1 A
30V DC/0,01...1A
1 2 3
inductive
Use of internal voltage supply
6 7 10 11
Use of external voltage supply
6 7 10 11
13...30VDC
PE
R= 3...10 kΩ
0...10 VDC
+
Ri = 56 kΩ
0(4)...20 mADC
+
Ri = 250 Ω
+15V
12 13 14 15
+
ext. voltage supply
16...30VDC
13 14 19 20
13 14 19 20
+
set-point setting
PE
8 9 18
0...±10 DCV
+ -
Ri= 40 kΩ
SPS
250V AC / 0,2 mA
30V DC / 1 A
30V DC/0,01...1A
18 21 22 23
Analog output:
0...10VDC / max. 5mA
Ri < 100 Ω
+
GB
PE
PE
PE
27