Cleaning The Burner - Angelo Po 090GRG Manual De Uso

To carry out this operation, proceed as follows.
1 - Remove the plate, the splashguard frame and
the grid clearance reduction (see page 12).
2 - Lift and remove the burner (A).
3 - Clean the burner (A) and check that its holes
are not blocked.
Caution - warning
Take care never to pour water or allow dirt to
fall into the burner as this will cause the burn-
er to malfunction.
4 - Clean the interior of the device and drain all res-
idue into the drip tray.
Caution - warning
Check that the burner (A) bushing (B) is not
blocked.
5 - Undo the screws (C), remove the drip tray
(D), empty it and clean it.
6 - Remove the drip tray (E), drain it and cle-
an it.
7 - Restore the initial conditions after completing
the operation.
IT
IT
GB GB
DE DE
FR FR
ES ES
English

CLEANING THE BURNER

B
D
- 14 -
A
IDM-39616500900.tif
C
IDM-39616501001.tif
E