Interface Overview; Chiropro Plus 3 Rd Gen Modes; Rotating Knob Functions Overview - Bien-Air Dental Chiropro Plus 3rd Gen Instrucciones De Uso

6 Interface overview

6.1 Chiropro Plus 3
The Chiropro Plus 3
operation parameters by the means of the LCD display.
A unique screen allows to use the following modes:
FIG. 1
• Operation mode (to perform an operation in 3 steps)
See chapter "7 Operation - Implantology mode" on page 14 for
details.
FIG. 2
• Settings mode (to set up operation parameters)
See chapter "9 Settings" on page 18 for details.
FIG. 3
• Special modes (to test system and reset settings)
See chapter "10 Special modes" on page 20 for details.
FIG. 4
A. Long press on the rotating knob (1) to switch between
Operation and Settings modes.
Note 1
See chapter "6.2 Rotating knob functions overview" on page 12 for
details.
See chapter "10 Special modes" on page 20 for entering special
modes.
12
FIG. 1
rd
Gen modes
rd
Gen allows to visualize and control

6.2 Rotating knob functions overview

Note 2
Knob action Description
Increase current value, go to the element
CW rotation
on the right
Decrease current value, go to the element
CCW rotation
on the left
One short press Go to the next programmed step,
(Operation mode) acknowledge error messages
Enter selected setting, validate and store
One short press
the current setting value, exit the current
(Settings mode)
setting, acknowledge error messages
Switch between Operation and Settings
One long press
modes
Double short Enter special modes (only when gear
press ratio is selected in settings mode)
FIG. 2