Operation - Implantology Mode; Operation Screen Description; Perform An Operation, Steps P1 And P2; Perform An Operation, Steps P3, P4 And P5 - Bien-Air Dental Chiropro Plus 3rd Gen Instrucciones De Uso

1 2 3

7 Operation - Implantology mode

7.1 Operation screen description

FIG. 1
The Operation screen differs whether the micromotor is stopped
or running and depending on the active step.
It allows to perform an operation in 3, 4 or 5 predefined steps P1,
P2, P3, P4, P5 (which can respectively be used to program
settings for the bone preparation, drilling, threading and implant
insertion phases), and displays the following information:
(1) Step P1 (inactive step, in black)
(2) Step P2 (inactive step, in black)
(3) Step P3 (active step, in green)
P4 and P5 steps are disabled by default, see " Number of steps" on
page 20 for enabling them.
(4) Speedometer
Note 1
(5) Torquemeter
Note 2
(6) Contra-angle ratio
Note 3
(7) Bar graph for torque
Note 4
(8) Operation settings symbols
See chapter "9 Settings" on page 18 for details on adjusting settings.

7.2 Perform an operation, steps P1 and P2

FIG. 2
A. Operate by pressing the footpedal to adjust the MX-i LED
micromotor speed.

Inactive steps symbols turn off when the motor is running.

Speedometer displays real-time speed value in black.
Note 5 - 6 - 7
FIG. 3
B. If necessary, release the footpedal to perform the following actions:

Speedometer (1) displays the set micromotor maximum
reachable speed in cyan.
14
4 5 6
8
FIG. 1
7
• Turn the knob CW or CCW to respectively increase or
decrease the micromotor maximum reachable speed (quick
setting mode).
Note 12

The speedometer is cyan and displays the set micromotor
maximum reachable speed (1).
Note 8
• Long press on the knob to change operation settings.

The Settings mode is displayed.
See chapter "9 Settings" on page 18 for details.
• Long press on the orange button of the footpedal to activate
the 5 Ncm torque boost.
Note 9 - 12
C. Short press on the footpedal's orange button or on the knob to go
to the next step.

The next step symbol turns green and the step's last used
settings are restored.
Note 7 - 10

7.3 Perform an operation, steps P3, P4 and P5

FIG. 4
A. In steps P3 (1), P4 and P5, operate by pressing the footpedal to
adjust the MX-i LED micromotor speed.

All inactive steps symbols turn off when the motor is running.

Speedometer (2) displays real-time value.

Torquemeter (3) displays real-time value.

The torque bar (5) displays ratio between the real-time torque
value (represented by cyan dots when the micromotor is
running) and the maximum reached torque (represented by
green dot).
Note 5 - 6 - 7
1
FIG. 2