Specific Information - Camp Safety 2016/425 Manual De Instrucciones

accidents or negligence, use for which this product is not specifically designed.
INSTRUCTIONS FOR USE
Summary
These pulleys are Personal Protective Equipment (PPE) certified according EN 12278. This product is intended for use
to protect and prevent against the risk of falling from a height in rescue operations, in work at a height, in the practice of
mountaineering, rock-climbing and other vertical sports that use similar techniques. The pulley is a device for reducing
the friction of a loaded rope so that heavy loads can be more easily lifted or lowered (see Table A).
Use
The choice of rope, suitable load and efficiency are shown in Tables A and figures 1-2.
The pulley must be attached to a safe anchor. The rope must run in the groove of the sheave [6] (fig.3). For the Janus
and the Dryad the main attachment holes [1] of the two side plates [4] and the central plate [5] must be clipped together
(fig.4). For the Naiad, do not clip the main attachment hole [1] with a secondary attachment hole [2] or with the becket
[3] (fig.5). The Naiad and the Janus can be used for tyrolean traverses including safety line (fig.6).
Some examples of pulley block are indicated in Table B. Humidity and cold temperatures may change the dynamic
performance of this product but will have no influence on its resistance. The use of gloves is recommended while using
pulleys.
CHECKING AND MAINTENANCE
Check the wheel's rotation before use. If after cleaning, the wheel does not turn freely, lubricate the axis of the wheel
with a silicon lubricator. Note: Cleaning and lubrication is recommended after every use in a marine environment.
If, after oiling, the defect persists, the pulley must be taken out of use.
REVISION
In addition to the normal inspection required before, during and after each use, this product must be inspected by a
skilled person every 12 months, starting from date the product is first used; this date and the subsequent checks must
be recorded on the product's life sheet: keep this literature for inspection and reference for the life of the device. Check
the legibility of the product's markings.
In case of one of the following defects are present, the product should be withdrawn from service immediately:
• malfunction or slackening of the wheel on the axle
• presence of cracks in the metallic parts
• permanent deformation of a metallic part
• deep corrosion that seriously alters the surface state of the metal (which does not disappear after a light rubbing with
emery paper)
• wheel's use causes a detectable reduction of the groove in the pulley wheel
Any product or component showing any defect or wear, or if in doubt, should be withdrawn from service immediately.
Each product in the safety system can be damaged during a fall and must be always inspected before use it again. Do
not continue to use a product after a major fall because a damage may have occurred, even no external signs are
visible.
LIFETIME
The lifetime of the product is unlimited, unless any defect appears and provided that periodic inspections are made at
least once every 12 months from the date the product is first used and the results are recorded in the life sheet of the
product. The following factors can reduce the lifetime of the product: intense use, damage to components of the
product, contact with chemical substances, high temperatures, tears and abrasions, violent impacts, failure to maintain
as recommended. When suspect that the product is no more safety and reliable, please contact C.A.M.P. spa or the
distributor.

SPECIFIC INFORMATION

18