Closing The Door; Installation; Ventilation Requirements - AEG SKS51240S1 Manual De Instrucciones

12 www.aeg.com
2
3. Replace the lamp with one of the
same power and shape, specifically
designed for household appliances.

8. INSTALLATION

8.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate
class
SN
N
ST
T
Some functional problems
might occur for some types
of models when operating
outside of that range. The
correct operation can only
be guaranteed within the
specified temperature
range. If you have any
doubts regarding where to
install the appliance, please
turn to the vendor, to our
customer service or to the
nearest Service Centre
8.2 Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
1
1
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
(the maximum power is shown on the
light bulb cover).
4. Reassemble the lamp cover.
5. Connect the plug to the mains
socket.
Open the door. Make sure that the light
comes on.

7.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the After Sales
Service.
rating plate correspond to your
domestic power supply.
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the
E.E.C. Directives.

8.3 Ventilation requirements

The airflow behind the appliance must
be sufficient.
min.
5 cm
200 cm 2
min.
200 cm 2