Safety Instructions - Stalgast 9725000 Instrucciones De Uso

Thank you for purchasing our product. Please carefully read this instruction manual before fi rst use.
Reproduction of this manual without the consent of the manufacturer is prohibited.
The photos and drawings are for illustrative purposes only and may differ from the purchased device.
CAUTION: The manual should be kept in a safe place, available to the staff. The manufacturer reserves the right to change
the technical parameters of the device without prior notice.

1. SAFETY INSTRUCTIONS

• Caution! If the device was damaged during transport it should not be connected!
• Incorrect operation and improper use may result in serious damage to the device or injuries to persons.
• The device should only be used for the purpose for which it was designed.
• The manufacturer assumes no liability for any damages caused by incorrect operation and improper use of the device.
• During operation the device and the power cable plug must be protected against contact with water or other liquids. If
the device accidentally fell into water or was fl ooded with water, it is necessary to immediately pull out the plug from the
socket, and then commission the inspection of the device to an expert technician.
Failure to follow this instruction may cause life-threatening situations.
• Never open the housing of the device on your own.
• Do not insert any objects into the openings in the housing of the device.
• Do not touch the power cord plug with wet hands.
• Regularly inspect the condition of the plug and the power cord. In the event any damage to the plug or the cable is fo-
und, it should be repaired in an authorized repair point.
• In case the device falls or is damaged in any other way, before further use it is always necessary for it to be inspected and
possibly repaired at a specialized repair point.
• Never attempt to repair the device on your own - it could lead to life-threatening situations.
• It is prohibited for any changes and repairs to be performed by unauthorized persons.
• Protect the power supply cable from contact with sharp or hot objects and keep it away from open fl ames. If you want
to disconnect the device from the electrical socket, always grab it by the plug and never pull by the power cable.
• Secure the power cable to ensure that no one pulls it from the socket by mistake and that no one trips over the cable.
• Control the operation of the device during use.
• Do not allow for the device to be used by minors, people with physical or mental disabilities and people with impaired
mobility, as well as persons without the appropriate experience and knowledge regarding the proper use of the device.
Such persons can operate the device only under the supervision of a person responsible for safety.
• If the device is not currently in use or is cleaned, it is necessary to always unplug it from the power source by removing
the plug from the socket.
• CAUTION: If the plug of the power cord is connected to the electrical socket, the device remains energized.
• Switch the device off before pulling the plug from the power socket.
• The device must be well visible and easily accessible after the installation.
• It is necessary to provide easy access to the socket of a non-detachable power cable.
2. OCCUPATIONAL HEALTH & SAFETY RULES
In order to prevent burns and electric shock please observe the following safety rules:
• Personnel using the appliance must be trained in the safe operation in accordance with the information in this manual as
well as the basic principles of use of electrical and workplace safety equipment. In the aforementioned areas, pre-training
(before the employee's fi rst use of the machine) and periodic training must be carried out for personnel.
• Do not leave the turned on device unattended due to the possibility of oil overheating. Unplug the device from
the power supply when it is not used and prior to maintenance.
• It is prohibited to turn the device on, if any heating element and/or control element is damaged. Before starting, make
sure that the unit is in working condition and that it is prepared to operate in accordance with this manual.
• Make sure that the power cord does not touch the hot surfaces of the appliance, that it is outside the heating compart-
ment, and that it is not exposed to cuts.
• Before fi lling the device, make sure the drain valve is closed (the lever is tilted to the left and the safety lock is lowered –
Fig. 10 Pos. 1 and Pos. 3)
• The oil level in the heating compartment must be between the "MIN" and "MAX" markings on the inside of the unit's
compartment.
• It is prohibited to pour water on the device. Products with high water content and excessive quantities of products
prepared at a time may lead to burns.
• Heating the oil causes the emission of its vapors. Therefore, ensure proper ventilation in the areas where the fryer is
used.
• There should be no fl ammable items near the device.
• During operation, the unit heats up. It is important to be aware of the possibility of burns on contact with its surface and
with oil in the compartment. When the device is turned off, its temperature drops slowly. Make sure that the bowl is
empty and the temperature of the appliance has dropped to a safe level before transport or any maintenance work.
• Before draining oil from the compartment, make sure that the elbow is screwed into the tap (Fig. 10 Pos. 2 and Pos. 4)
as instructed, and the oil temperature has dropped to a safe level.
- 13 -