ASSEMBLY
• Line up the front fender and press onto
the front frame assembly (Fig. 5c).
• Insert the 4 screws through the underside
of the front frame assembly into the front
fender's plastic tubes. Tighten the screws
only until snug (Fig. 5d).
DO NOT OVER TIGHTEN.
REAR WHEEL
6) • Lean the stroller forward to rest on the
front wheel. To attach the rear wheels,
push each wheel's axle into the plastic
corner fitting (Fig. 6). Depress the metal
lever on the inside of the corner fitting
as you push the axle into corner fitting.
When the wheel will not go on any
farther, release the lever.
NOTE: Check that the wheel has locked
into the corner fitting by pulling on the
wheel. If not locked, lift upward on the
lever, push the wheel on farther and
release lever.
• Ensure that the wheels are firmly
locked into place.
use the
NEVER
stroller if the wheels are not locked into
place, contact our customer service
department immediately at 1-800- 328-
7363, between the hours of 8:00am and
4:30pm PST, for assistance.
7
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
PARENT TRAY
7) • To attach the parent tray, align the
Fig. 5c
• To remove the parent tray, pull outward
Fig. 5d
CANOPY
8) • To open the canopy: push forward on the
Fig. 6
9) • To fold the canopy: pull backwards on
WARNING:
Do not place hot liquids or more
than 3 pounds in the parent tray. Serious burns or
unstable conditions could result.
fittings on the ends of the parent tray
with the fittings on the outsides of the
handle. Hook the hole in the parent tray.
Pull outward on the opposite end while
pushing down on the tray until locked
onto the stroller handle. Please be
careful not to pinch your fingers when
installing the parent tray (Fig. 7).
on one end of the tray while lifting
upward.
front edge of the canopy while holding
the rear of canopy in place (Fig. 8).
the front edge (Fig. 9).
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 7
Fig. 8
Fig. 9
8