List Of Components - Inglesina Amerigo HSA Ifix Manual De Instrucciones

INSTRUCTIONS

LIST OF COMPONENTS

fig. 1
A
Adjustable headrest
B
Reclinable backrest
C Red strap lock
D
Centralised adjustment device of strap unit
E
Safety belt central buckle
F
Bottom red strap guide
G
Inclination adjustment device
H
Headrest adjustment lever
K Strap unit adjustment belt
J
Support foot articulation
L
Support foot
M
Pushbutton for Isofix connector's disengagement
N
Indicators of Isofix connector's engagement
O
Support foot adjustment pushbutton
P Isofix connectors
Q Levers for the Isofix connector's extension
R
Plastic guides for Isofix connector's
INSTALLATION OF CHILD CAR SEAT IN VEHICLE
METHOD 1: ISOFIX CONNECTORS
IMPORTANT
ATTENTION! Install the Amerigo HSA Ifix child car seat only with the
backrest placed on the seat back of the car and on passenger seats
facing forwards. Never install it on seats facing the opposite direction
or sideways to normal motion.
Privilege installation on rear seats; if installed in the front, adjust the
car seat as far back as possible.
If the vehicle has a front seat airbag, scupulously comply with the
provvisions carried in the instruction manual of the car concerning
use and maintenance of this protective device; in any event, move
the car seat where you wish to install the child seat as far back as
possible.
If the seat is not all the way back, we advise you deactivate the airbag.
ATTENTION! Activation of the airbag at too close a distance can en-
tail serious risks for the heatth of the child.
Verify that on the seat of the car there are not any items that may
hinder the correct leaning of the Amerigo HSA Ifix child car seat.
Make sure that the back of the car seat where the child car seat is to
be installed is in the upright position, properly blocked and as far
back as possible.
When the child car seat is installed in rear seats, make sure to move
the seat in front of it forwards, at a distance which keeps the feet of
the child from being hit.
fig. 2
Turn the foot support (L) completely, bringing it to the
upright position.
fig. 3 In order to prepare the seat for installation, act on the 2 le-
vers (Q) at the side of the seat's base simultaneously and push hard
on the joint of the foot support (J) in order to remove both Isofix
connectors (P).
fig. 4
The Amerigo HSA Ifix child car seat has 2 guides (R) to be
used if the vehicle has none, in order to position the Isofix connectors
correctly (P) in line with the anchor points on the car's seat. If neces-
sary, fasten the 2 guides (R) on the anchor points of the car's seat.
36