General Information; Preparation For Installation; Instructions For Use - Varian Turbo-V 2000 ICE Manual De Instrucciones

GENERAL INFORMATION

This equipment is destined for use by professionals. The user
should read this instruction manual and any other additional
information supplied by Varian before operating the equipment.
Varian will not be held responsible for any events occurring due
to non-compliance, even partial, with these instructions, im-
proper use by untrained persons, non-authorized interference
with the equipment or any action contrary to that provided for by
specific national standards.
The Turbo-V 2000 ICE series pumps are turbo-molecular
pumps for high and ultra-high vacuum applications and can
pump any type of gas or gas compound. They are not suitable
for pumping liquids or solid particles. The pumping action is
obtained through a high speed turbine (max. 33000 rpm) driven
by a high-performance 3-phase electric motor. The Turbo-V
2000 ICE pumps are free of contaminating agents and, there-
fore, are suitable for applications requiring a "clean" vacuum.
The following paragraphs contain all the information necessary
to guarantee the safety of the operator when using the equip-
ment. Detailed information is supplied in the appendix "Techni-
cal Information".
This manual uses the following standard protocol:
WARNING!
The warning messages are for attracting the attention of the
operator to a particular procedure or practice which, if not fol-
lowed correctly, could lead to serious injury.
CAUTION
The caution messages are displayed before procedures which,
if not followed, could cause damage to the equipment.
NOTE
The notes contain important information taken from the text.
STORAGE
When transporting and storing the pumps, the following envi-
ronmental requirements should not be exceeded:
−
temperature: from -20° to +70 °C
−
relative humidity: 0 - 95% (non-condensing)
If the storage time is long start the pump using the SOFT
START mode (see control unit manual).

PREPARATION FOR INSTALLATION

The pump is supplied in a special protective packing. If this
shows signs of damage which may have occurred during trans-
port, contact your local sales office.
When unpacking the pump, be sure not to drop it and avoid any
kind of sudden impact or shock vibration to it.
Do not dispose of the packing materials in an unauthorized
manner. The material is 100% recyclable and complies with
EEC Directive 85/399.
CAUTION
In order to prevent outgassing problems, do not use bare hands
to handle components which will be exposed to vacuum. Al-
ways use gloves or other appropriate protection.
NOTE
Normal exposure to the environment cannot damage the pump.
Nevertheless, it is advisable to keep it closed until it is installed
in the system, thus preventing any form of pollution by dust.
INSTALLATION
Cause its weight, the pump must be handled by means of suit-
able moving and handling tools.
Use the suitable handling kit eyebolts screwing them into the
M8 holes of the pump envelope.
Ensure that the pump is suitable for your application. The pump
is designed for PVD system pumping applications or clean
general vacuum applications. Contact Varian Vacuum Tech-
nologies or your supplier if you want to use the pump on any
other application.
Do not install or use the pump in an environment exposed to
atmospheric agents (rain, snow, ice), dust, aggressive gases,
or in explosive environments or those with a high fire risk.
Do not remove the adhesive and protective cap before con-
necting the turbopump to the system.
23

INSTRUCTIONS FOR USE

WARNING!
CAUTION!
87-900-915-01(E)