Install Duct Covers; Complete Installation; Range Hood Use; Range Hood Controls - ELICA EVL430S1 Guía De Instalación, Uso Y Mantenimiento

Install duct covers

When using both upper and lower vent covers, push lower
cover down onto hood and lift upper cover to ceiling and
install with two mounting screws.
NOTE: For vented installations, the upper vent cover may be
reversed to hide slots.
D
C
A. Upper vent cover
B. Lower vent cover
C. 2.9 x 6.5 mm screws for models EVL43
4.2 x 8 mm screws for models EPT43 & ETB43
D. Bracket
Secure the bottom of the duct with 2 - 4.2 x 8 mm screws
(only models EPT43 & ETB43).

Complete Installation

1. For non-vented (recirculating) installations only, install
2. Install metal filters. See the "Range Hood Care" section.
3. Check the operation of the range hood blower and light.
NOTE: To get the most efficient use from your new range
hood, read the "Range Hood Use" section.
C
A

Range Hood Use

B
The range hood is designed to remove smoke, cooking
vapors and odors from the cooktop area. For best results,
start the hood before cooking and allow it to operate several
minutes after the cooking is complete to clear all smoke and
odors from the kitchen.
The hood controls are located on the front side of the canopy.

Range Hood Controls

Operating the light
The On/Off light button controls both lights. Press once for On
and again for Off.
Operating the blower
The Blower Speed buttons turn the blower on and control the
blower speed and sound level for quiet operation. The speed
can be changed anytime during fan operation by pressing the
desired Blower Speed button.
The Blower Off button turns the blower Off.
11
charcoal filters over metal grease filter. See the "Range
Hood Care" section.
See the "Range Hood Use" section.
A
D
A.Grease filter
B.Grease filter handle
C. Blower and light controls
D. Halogen lamps
A B C
A. On/Off light button
B. Blower off and speed minimum button
C. Blower speed medium button
D. Blower speed maximum button
B
C
D