Installing The Range Hood; Connect Vent System - ELICA EVL430S1 Guía De Instalación, Uso Y Mantenimiento

Installing the range hood

1. Using 2 or more people, hang range hood on 2 mounting
screws through the mounting slots on back of hood.
MODELS EVL43
A
MODELS EPT43 & ETB43
A
A. Mounting screws
B. Mounting slots
C. Lower mounting screws
2. Remove the grease filter. See "Range Hood Care"
section (only for models EVL43).
3. Level the range hood and tighten upper mounting screws.
4. Install 2 - 5 x 45 mm lower mounting screws and tighten.

Connect Vent System

1. Install transition on top of hood (if removed for
B
For vented installations only:
1. Fit vent system over the exhaust outlet.
2. Measure from the bottom of the air deflector to the bottom
C
B
3. Seal connection with clamps.
4. Check that back draft dampers work properly.
C
9
shipping) with 2 - 3.5 x 9.5 mm sheet metal screws.
A
B
A. Vent transition
B. 3.5 x 9.5 mm screw
of the hood outlet. Cut the ductwork at the measured
dimension.