FLAEM Air Pro 3000 Manual De Instrucciones página 11

• The device casing is not waterproof. Do not wash the device under running water or by immersion and
keep it safe from being sprayed by water or other liquids.
• Do not expose the device to particularly extreme temperatures.
• Keep the device away from sources of heat, direct sunlight or excessively warm locations.
• Do not obstruct or introduce objects in the filter and its relevant housing in the device.
• Never obstruct the air inlets positioned on both sides of the device.
• Always operate the device on an unencumbered hard surface.
• Before every utilisation ensure the ventilation slits are not obstructed by any material.
• Do not insert any objects into the ventilation slits.
• Always unplug the power cable immediately after use.
• The device is equipped with an easy to inspect safety fuse in case of malfunction. Before doing so,
unplug the power cable. Repairs must be done only by authorised FLAEM personnel. Unauthorized
repairs will void the warranty and may pose a hazard to the user.
• The average operating life of the compressor is 2,000 hours approximately.
ATTENTION: Do not modify this device without authorisation from the manufacturer.
• The Manufacturer, the Vendor and the Importer shall be held responsible for safety, reliability and per-
formance only if: a) the device is used in compliance with the instructions for use b) the wiring where
the device is being used is in compliance with safety regulations and current laws.
• Interactions: the materials used which are in contact with medications have been tested with a wide
range of pharmaceuticals. However, in view of the variety and continuous evolution of pharmaceuti-
cals, interactions cannot be ruled out. We recommend the medication is used as soon as possible
after opening and its prolonged exposure to the nebuliser is avoided.
• The Manufacturer must be contacted to communicate unexpected problems/events related to func-
tioning.
OPERATING INsTRuCTIONs
Before each utilisation, wash your hands accurately and clean the device as described in the para-
graph "CLEANING, sANITIsATION AND DIsINFECTION". During application it is advisable to suit-
ably protect oneself from any dripping. The nebuliser and accessories are for personal use only in
order to prevent any risks of infection.
It is recommended to replace them every six months.
1. Insert power supply cord (A7) into socket (A6) and then connect it to a mains outlet adequate to the
device voltage. The position of the socket must be such that the device can be easily unplugged from the
mains network
1
2. Open the nebuliser by turning
the top (C5.1) anti-clockwise.
2
11
3. Pour the medication prescribed
by the doctor into the bottom
part (C5.3)