Troubleshooting - FLAEM Air Pro 3000 Manual De Instrucciones

- Fill a container, suitable to contain all the individual components to be disinfected, with a solution of
drinking water and disinfectant, while respecting the proportions indicated on the packaging of the
disinfectant itself.
- Completely immerse each individual component in the solution, taking care to avoid the formation of
air bubbles in contact with the components. Leave the components immersed for the period of time
indicated on the packaging of the disinfectant, and associated with the concentration chosen to prepare
the solution.
- Remove the components now disinfected and rinse thoroughly with lukewarm drinking water.
- After disinfection shake the accessories vigorously and place them on a paper towel, or alternatively,
dry them with a jet of hot air (e.g. using a hair dryer).
- Dispose of the solution as recommended by the disinfectant manufacturer.
AIR FILTERING
The device is equipped with a suction filter under the Filter Lid Cover (A3),
which must be replaced when it is dirty or changes colour. To replace it,
lift the Filter Lid Cover (A3), and remove the filter.
Do not wash or reuse the same Filter. Regular filter replacement is nec-
essary to assure proper compressor performance. The Filter must be
regularly checked. Contact your retailer or authorised service centre for
replacement filters.
TROuBLE-sHOOTING
Switch off the device before any procedure and unplug the power cable from the socket.
PROBLEM
The device does not work
The device does not nebulise or
nebulises insufficiently.
The apparatus is noisier than usual
If after verifying the above mentioned conditions the device should not operate properly, contact your trusted retailer or the
nearest authorised FLAEM service centre.
CAusE
The power cable has not been cor-
rectly inserted into the socket of
the device or the power socket
The medication has not been in-
serted in the nebuliser.
The nebuliser has not been prop-
erly fitted.
The nebuliser nozzle is clogged.
The air pipe is not correctly con-
nected to the device
The air pipe is bent, damaged or
twisted
The air filter is dirty
The Filter lid cover is not correctly
inserted in its housing
15
sOLuTION
Correctly insert the power cable in
sockets.
Pour the right amount of medica-
tion in the nebuliser.
Disassemble the nebuliser and
reassemble it correctly as shown
in the connection diagram on the
cover.
Disassemble the nebuliser, remove
the nozzle and perform cleaning
operations Failure to remove medi-
cation deposits from the nebuliser
affects its efficiency and operation
Strictly comply with the instruc-
tions contained in the CLEANING,
SANITISATION AND DISINFEC-
TION chapter
Ensure the device's accessories
are properly connected to the air
intake (see connection diagram on
the cover).
Unwind the pipe and ensure it is
not crushed or punctured. If nec-
essary replace it.
Replace the filter
Fully and properly insert the Filter
lid cover in its housing