Stand Base; Stand Assembly; Stand Base Assembly; Light Body On Stand - KaWe MASTERLIGHT LED 4000 Instrucciones De Empleo

Stand Base Assembly Instructions, User's Manual Assembly Instructions STAND FOOT – STAND TUBE
10. SAFETY NOTICE
The floor stand may only be plugged into an electrical
outlet after it has been fully assembled.
Repair work on the stand and especially assembly work
on the sliding contacts may only be performed by us or
by someone authorised by us to do so.
The manufacturer is only responsible for the safety of
the stand if repairs and modifications were performed
by the manufacturer or at a place that is guaranteed to
comply with the safety regulations.
The manufacturer is not liable for any injuries or prop-
erty damage if the stand is not used for its intended
purpose or operated incorrectly.
General information
These assembly instructions must be stored with the
user's manual for the examination light for future
reference.
All KaWe examination lights are delivered with all of the parts required
for assembly and connection.
In order to reduce the packaging volume, the five-footed base of the
floor stand comes disassembled. The stand post is always assembled
as one piece and must only be attached to the base with its lower
fastening screw.
The KaWe examination light (stand post or cross arm) is equipped
with an integrated power cord and safety plug.
The electrical outlet used must be installed according to IEC and VDE
0107 regulations.
Check to see if there is a Schuko electrical outlet within the operating
range of the light.
28
11. ASSEMBLY OVERVIEW
Stand height adjustable - for KaWe examination lights with short,
fixed arm.
12. SUMMARY TABLE
Stand base – stand post – cross arm
Data by lamp type: Light
230 V AC
Primary
(120 V AC optional)
Power supply Secondary 24 V (DC at 18 and 20 LED)
50 W (60 W at 18 and
Transformer
20 LED)
Number of feet 5
Foot length 310 mm

Stand base

Castors Ø 50 mm
Note Weighted
Length approx. 84 - 138 cm
Diameter 40 mm
Stand post
Telescoping Yes
Power cord
None
connection
Cross arm +
Assembly

Light body on stand

light body
13. ASSEMBLY INSTRUCTIONS
Parts included:
• Stand base – five-foot base with profile feet and hardware
• Stand post
• Light body with short arm / cross arm
• Assembly instructions
• User's manual for the KaWe examination light

13.1 Stand assembly

13.1.1 Stand base assembly

The assembly procedure for the stand base is the same for all models.
Assemble the stand base as follows:
• Insert the supplied hex nuts 1 into the depressions 2 on the connec-
tion struts.
• Press the plastic sleeves 3 onto the nuts.
• Place the metal disc 4 into the depression on the centre piece 5.
Note: Ensure that the feet with the locking castors are posi-
tioned such that they are exactly opposite one another (see
detail A).
• Insert the included screws 7 and the spring washers 8 into the bore-
holes and tighten them with a wrench until the feet are fastened
securely.
13.1.2 Light body on stand
Telescoping floor stand
Before placing the stand post onto the base, ensure that the grounding
strip 9 on the foot is bent such that the fastening screw can be inserted
through the hole on the grounding strip.
Light body on stand
Insert the stand post into the base and secure it with the included
wing nuts 13 and washers 14.

13.2 Lamp arm/short arm and light body assembly

13.2.1 Attaching the examination light to the short arm
Before the short arm can be secured to the stand post, the light body
must be attached to the short arm.
Position the light body and the short as shown. The peg of the short
arm must be rotatable in the downward direction.
Insert the light completely into the short arm.
29