KaWe MASTERLIGHT LED 4000 Instrucciones De Empleo página 16

• Swivel the short arm upward.
• Tighten the four set screws (see marking) by hand.
• Mount the short arm and attached lamp onto the stand post as de-
scribed in section 13.2.2.
13.2.2 Attaching the lamp arm/short arm to the lamp post
The stand post has a socket on its upper end in which the pins on the
cross arm or the short are inserted.
The stand post comes with a fully retracted telescoping tube.
As the telescope has an integrated spring counterbalance system that
keeps the mounted light body exactly in the desired location, for trans-
port reasons, it is secured by screw 1 in its fully retracted position. This
screw is to be removed in the following manner: Hold the telescoping
tube steady and after removing the screw, allow it to slowly extend
until it is all the way out.
30
14. USER'S MANUAL
14.1 Base
The 5-footed floor stand has two locking castors, which are located
opposite one another. The castor is locked by pressing down on the
tab in front of the castor. The castor can be unlocked by gently lifting
up on the tab.
14.2 Stand post
The height of the stand post can be infinitely adjusted with just one
hand and remains precisely positioned at the desired height.
The height can be adjusted by simply lifting the telescoping stand post
2. The post will stay at the selected height.
15. CLEANING
Alc. 20%
The surface of the floor stand can be easily kept clean by wiping it with
a damp cloth. Any common cleaning agents may be used.
Should disinfection be necessary, the use of an agent that is either
dissolved in water or max. 20% alcohol is recommended.
16. MAINTENANCE
Caution!
All models may only be serviced if the power cord has
been unplugged.
When assembling the KaWe examination light and once per year
thereafter, the mounting pin and the groove are to be lightly greased
with non-acidic grease.
Adjusting the spring tension
If the light no longer stays in the desired position, proceed as follows:
• Remove the light body. Loosen the threaded pin 4 M5x10 in the cap
ring of the telescoping tube until the light body can be pulled up out
of the stand post
• Push the telescoping tube of the stand post all the way down until
it is at its lowest point. Inside of the tube you will see an adjustment
screw.
• Turn the adjustment screw with a screwdriver as follows:
a. If the lamp body does not stay in place and keeps sink-
ing: turn the screw clockwise. This increases the tension.
b. If the lamp body is hard to move upward: Turn the screw
counter-clockwise. This decreases the tension.
17. DISPOSAL
The floor stands do not contain any hazardous materials.
At the end of the product life, the components of the KaWe exami-
nation light are to be disposed of properly. Ensure that the materials
are sorted carefully according to type. The floor stand parts are to be
disposed of appropriately according to their type of material.
31