Orbit 28954 Manual Del Usuario página 13

• Press the [+/–] to enter the desired duration from
1 to 240 minutes .
• Wait 5 seconds and your station will begin.
• To stop Manual Watering press [CLEAR].
• The timer will go back to your original automatic
watering schedule .
Example: To manually water on station 3 for five
minutes, press the [MANUAl] button then press
the [   ] buttons until you see station 3; using
the [+/–] buttons, set duration to five minutes;
press [eNTeR] .
Note: After the [MANUAL] button has been pushed, if a
selection is not made within 5 seconds all stations and
programs will begin watering using the programmed
RUN TIMES. If no RUN TIMES have been set, nothing will
happen and the display will return to the time of day.
Connecting a Rain Sensor
• Connect the rain sensor wires to the wiring
terminal ports (yellow in color) labeled "sensor"
(see figure 6) .
Note: Refer to your rain sensor manual for specific
wiring instructions.
• Place the sensor on/off switch to the "on"
position to begin operation .
13
Rain Sensor Bypass
This sprinkler timer is equipped with a sensor
override "on/off" switch . This switch is for use during
maintenance and repairs, so the sprinkler timer can
be operated even if the rain sensor is in active mode .
Important: If the rain sensor switch is in the "on"
position and no sensor is connected, the sprinkler
timer will not operate . To resume sprinkler timer
operation place the switch in the off position .
TIMER
1 2 3 4
SENSOR COM
24VAC
Figure 6:
Connecting a
Rain Sensor