Section 2: Installation - Orbit 28954 Manual Del Usuario

Section 2: Installation

Required Tools
• Phillips Screwdriver
• Wire Strippers
1. Select a Location
When choosing a location for your timer, consider the
following:
• Choose a location near an electrical outlet .
• ensure operating temperatures are not below 32° or
above 158° Fahrenheit (below 0° Celsius or above 70°
Celsius) .
• locate the timer where there is easy access to sprinkler
wire (from valves) .
2. Mount the Timer
• Use the mounting template (included) to mark the
mounting screw location on the wall . See figure 1
• Install a No . 8 screw (included) into wall in the upper
template location . leave the screw head protruding 1/8"
(3mm) from wall . Use expanding anchors (included) in
plaster or masonry, if necessary, for a secure hold .
• slip the timer over protruding screw (using keyhole slot
in back of timer) . See figure 2
• drive a No . 8 screw through one of the two pre-formed
holes located in lower corners of the cabinet . See figure
2
Figure 1: Use Mounting Template (included)
Keyhole
Pre-formed
mounting holes
Figure 2: Hang timer on screw using keyhole
1/8"
No. 8 Screw
Wall
6