Features - Urrea SI910 Manual De Usuario

• Make sure that the blade shaft, flanges or
bolts are not damaged, as this could cause
blade breakage.
• Make sure that the rotary table is properly
secured so it will not move during operation.
• For your safety, remove the chips, small piec-
es, etc. from the tabletop before operation.
• To avoid cutting nails, inspect workpiece and
remove all nails before operation.
• Make sure the shaft lock is released before
the switch is turned on.
• Make sure that the blade does not contact
the rotary table in the lowest position.
• Hold the handle firmly. Be aware that the
saw moves up or down slightly during start-up
and stopping.
• Make sure the blade is not contacting the
workpiece before the switch is turned on.
• Before using the tool on an actual workpiece,
let it run for a while. Watch for vibration or
wobbling that could indicate poor installation
or a poorly balanced blade.
• Wait until the blade attains full speed before
cutting.
• Stop operation immediately if you notice
anything abnormal. Do not attempt to lock the
trigger in the on position.
• Be alert at all times, especially during repeti-
tive, monotonous operations. Do not be lulled
into a false sense of security. A single moment
of inattention can provoke serious injury.
• Always use accessories recommended in this
manual. Use of improper accessories such as
abrasive wheels may cause an injury.
• Do not use the saw to cut anything other
than wood.
• Connect miter saws to a dust collecting de-
vice when sawing. Take care when slotting.
• Replace the kerf board when worn.
• Do not use saw blades manufactured from
high speed steel.
• Some dust created from operation contains
chemicals known to cause many serious dis-
eases such as cancer. Some examples of these
chemicals are:
*Lead from lead-based-painted material and;
*Arsenic and chromium from chemically-
treated lumber.
• Your risk from these exposures varies, de-
pending on how often you do this type of
work. To reduce your exposure to these chemi-
E N G L I S H •
cals: work in a well ventilated area and work
with approved safety equipment, such as dust
masks that are specially designed to filter out
microscopic particles. To reduce the emitted
noise, always be sure that the blade is sharp
and clean.
• The operator is adequately trained in the use,
adjustment and operation of the machine.
• Use correctly sharpened saw blades. Observe
the maximum speed marked on the saw blade.
• Refrain from removing any cut-offs or other
parts of the workpiece from the cutting area
while the tool is running and the saw head is
not in the rest position.
• Wear gloves for handling saw blades (saw
blades shall be carried in a holder wherever
practicable) and rough material.
• Do not replace laser with one of a different
type.
• Use the ear protection during cutting to
avoid listening injury.

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1. HANDLE.
2. CARRYING HANDLE.
3. DUST EXTRACTION ADAPTER.
4. SLIDE LOCK KNOB.
5. VERTICAL CLAMP.
6. FENCE.
7. STOCK STOP.
8. STOP PIN.
9. SIDE EXTENSION TABLE.
10. TABLE INSERT.
11. ROTARY TABLE LOCK KNOB.
12. SELF-CLOSING BLADE GUARD.
13. LASER.
14. HEIGHT ADJUSTMENT SCREW.
15. CARBON BRUSHES.
16. MOTOR.
17. SLIDE GUIDE BARS.
18. BEVEL LOCK LEVER.
19. ROTARY TABLE.
20. BASE.
U se r's m a n ua l
17