Motorola TALKABOUT T92 H2O Manual Del Propietário página 11

Ocultar thumbs Ver también para TALKABOUT T92 H2O:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 37
To start Basic Scanning:
1. Press the
key briefly. The Scan
the display and the radio will begin to scroll through the
channel and code combinations.
2. When the radio detects channel activities matching the
channel and code combination, the radio will stop scrolling
and you can hear the transmission.
3. Press the PTT button within 5 minutes after the end of the
transmission to respond and talk to the person transmitting.
4. The radio will resume scrolling through the channels 5
seconds after the end of any received activity.
5. Press the
Scan/Monitor button briefly to stop scanning.
To start Advanced Scanning:
To set another channel and start Dual Channel Monitor:
1. Press the
Scan/Monitor button briefly. The Scan
icon will appear in the display and the radio will begin to
scroll through the channels. No Interference Eliminator
Codes will filter what is heard.
2. When the radio detects channel activities with ANY code (or
NO code), it stops scrolling and you can hear the
transmission. Any Interference Eliminator Code that may be
use by other party will be detected and displayed.
3. When you respond and talk to the person transmitting, press
the PTT button within five seconds after the end of the
transmission.
4. The radio will resume scrolling through the channels 5
seconds after the end of any received activity.
5. Press the
Scan/Monitor button briefly to stop scanning.
Scanning Notes:
1. The transmission will be on the "Home Channel" if you press
icon will appear in
the PTT button while the radio is scrolling through inactive
channels. You may press the
stop scanning at any time.
2. You may immediately resume the scan by briefly pressing
the
transmission.
3. You may temporarily remove that channel from the scan list
by pressing and holding
stops repeatedly on an undesired transmission. You may
remove more than one channel this way.
4. Turn the radio OFF and then turn back ON, or EXIT and re-
enter the scanning mode by pressing
button to restore and remove channel(s) to the scan list.
5. You cannot remove the "Home Channel" from the scan list.
6. In the Advanced Scan, the detected code will only be used
for one transmission. You must take note of that code, exit
scan and set the detected code on that channel to
permanently use the detected code.
Water Sensor
When the radio comes in contact with water, the WHITE LED
will begin flashing until the battery is dead. Press the Flashlight
button to turn off the flashing LED.
Scan/Monitor button to
or
if the radio stops on an undesired
or
for 3 seconds if the radio
Scan/Monitor
9

Publicidad

Tabla de contenido
loading

Tabla de contenido