Transportation And Installation; Transport And Unpacking; Disposal Of Packaging Materials; Installation Conditions - Dentsply Sirona inLab MC X5 Instrucciones De Uso

4 Transportation and installation
4.1 Transport and unpacking
14
4

Transportation and installation

4.1

Transport and unpacking

All products from Dentsply Sirona are carefully checked prior to shipment.
Please perform an incoming inspection immediately after delivery.
1. Check the delivery note to ensure that the consignment is complete.
2. Check whether the product shows any visible signs of damage.
NOTICE
Damage during transport
If the product was damaged during transport, please contact your
carrying agent.
If return shipment is required, please use the original packaging for
shipment.
4.2

Disposal of packaging materials

The packaging must be disposed of in compliance with the relevant
national regulations. Please observe the regulations applicable in your
country.
4.3

Installation conditions

4.3.1

Installation site requirements

The inLab MC X5 suction device requires an even base of approx. 400
mm x 400 mm (W x D).
The CEREC MC/MC X/MC XL Premium Package suction device requires
an even base of approx. 360 mm x 260 mm (W x D).
Install the suction device in such a way that the main switch can be
pressed easily. To enable simple replacement of the filter and bag, we
recommend orientating the maintenance flap to the front with the two
knurled nuts. The ventilation slots on the bottom side and rear side of the
suction system must be kept unobstructed. The distance between the
rear side of the unit and the room wall must be at least 30 mm. If the
suction device is integrated in a cabinet, this must be vented sufficiently
to prevent the suction device from overheating.
The suction device must not be set up in the immediate vicinity of
considerable humidity development.
Operating Instructions Suction devices for inLab MC X5 and
Dentsply Sirona
64 98 609 D3608
D3608.201.02.04.02 09.2017