⑵Names Of Major Parts And Components Of Tiller; ChapterⅣOperation Method Of The Tiller; ⑴Routine Check - LONCIN 1WG3.5-75FQ-D Manual De Uso

⑵ ⑵ ⑵ ⑵ Names of major parts and components of tiller
1.
Accelerator valve regulator
2
Extinguishing switch
3.
Handle pipe connecting part
4.
Gasoline engine
5.
Front wheel assembly
6.
Tilling blade
Before each tiller leaves the factory, it has gone through shakedown test, but the user still should
check all mechanisms of the machine and adjust them before actually using it, so as to let it work
better.
⑴ ⑴ ⑴ ⑴ Routine check
1. Check engine oil
Warning! The engine shall be filled with 0.6L of engine oil. If the level of engine oil is lower
than the normal one when the user is using the engine, the engine will be severely damaged!
Warning! Please use clean and high-quality engine oil for four-stroke engines. Use of dirty oil
or any other type of engine oil will shorten the engine's service life.
● Put the engine in a horizontal position.
● Screw out the oil dipstick of the engine and clean it by wiping it (See Fig.3)
● Insert the oil dipstick into the oil filler (don't engage their threaded parts)
● Take out the oil dipstick to check oil level, if it's within the marked range of the oil dipstick,
it is OK.
● SAE15W一40 engine oil is a recommended general-purpose lubricant, and is suitable for a
common ambient temperature. (See Table 1)
Figure 1
7.
Damping lever
8.
Reduction box
9.
Damping partmounting seat
10.
Lifting part
11.
Rear wheel assembly
Chapter IV Operation method of the tiller
4
Figure 2
12. Fender
13.
Belt guard
14.
Gear shift lever assembly
15.
Handle pipe assembly
16.
Clutch handle