Replacing The Belt; Solutions To Most Frequent Anomalies - Sima DUPLO Manual De Instrucciones Original

Grease at the end of the day greasing plate drag of the blades, use a pump grease for this.
Weekly clean water pump clean water flow deposit
To complete the maintenance and care of the gasoline engine, we recommend reading the manual on it has developed
its manufacturer, which is paired with the manual.
It is prohibited to independently make any change in some parts, components or characteristics of
the machine. SIMA, S. A. shall in no case be responsible for the consequences that may derive from a
breach of these recommendations.

11.1 REPLACING THE BELT

The transmission belts are terms that wears out and deteriorates with the normal use of the machine and it
must be replaced periodically. So we will withdraw the pulleys protection loosening its screws and make those
changes. This operation is not difficult because the engine is stopped and the belt tension is loosening.

12. SOLUTIONS TO MOST FREQUENT ANOMALIES

ANOMALY
Petrol engine does not start.
Electrical motor does not start
Gasoline engine does not accelerate
Blades do not turn with the motor
Machine bumps on the
surface
Low oil level alert is on.
Fuel clock closed
Motor switch in OFF position
Safety handle open
Loss of electrical supply
Damaged switch
Petrol cable interlocked or loose
Engine problems
Interlocked or damaged clutch.
Damaged belt
Reducer interlocked or damaged
Dry concrete rests in the central plate.
Blades irregular worn
working
Loose central plate
Bended arms
-11-
CAUSE SOLUTION
Add oil
Open fuel clock
Turn to ON position
Press and nail
Check the general electrical outlet.
Revise the correct position of the
differential and thermal. Verify perfect
state of extension cable and correct fit
on both extremities.
Replace
Revise lever and cable accelerator
Revise by technician
Revise and replace if necessary
Replace
Replace damaged elements.
Clean
Change
Tighten sufficiently
Replace.
ENGLISH