Viking GE 345 Manual De Instrucciones página 26

Sharpening Cutting Assembly
If the cutting quality deteriorates slowly
over time, the blades have probably
been blunted.
When re-sharpening the cutting
assembly the following points are to be
observed:
• Cool the blades during sharpening
(i.e. with water). The blades must not
become blue, or they will become
less resistant to wear.
• Sharpen the blade evenly, to avoid
vibrations resulting from imbalance.
• Inspect the blades for damage before
installation: They must be re-newed if
notches or cracks are visible, or if the
cutting edge has already been gro-
und back 3 mm (grinding limit).
Storage
The storage room should be dry, free
from dust, and inaccessible to children.
If the appliance is defective, repair it
prior to storage so that it is always in a
condition that is safe to use.
10 10
Design of cutting assembly
Multicut 300
0
1
3
4
6
7
The components of the blade
assembly must be offset at 90° to one
another (see illus.).
0 Clamping disc
1 Pre-mulcher
2 Combination blade
3 Multi-cut-disc
4 Square end
5 Ejector
6 Space pipe
7 Seal ring cover
VIKING recommends the use of original
VIKING tools, accessories and spare
parts. Their properties are optimally
adapted to the appliance and the user's
requirements.
Assembly - Disassembly
of the cutting assembly
2
2
17
5
• The installation must follow the
illustrated procedure.
• Tighten all bolts!
Important:
Danger of injury!
Always wear gloves when
working.
1
18
18
0478 215 9921 B - EN