Charging Instructions - Elinchrom ELB 500 TTL UNIT Manual De Funcionamiento

TO CONNECT YOUR BATTERY TO THE ELB 500 TTL UNIT:
1. Place the ELB 500 unit on a flat, dry and clean surface.
2. Place the charged Li-Ion ELB 500 Battery Pack on a clean
surface
3. Place the ELB 500 housing over the ELB 500 Battery Pack.
4. Press smoothly down onto the ELB 500 housing until you
hear two clicks (left / right)
5. Visually check, that the Battery Pack is well connected on
both sides of the unit.
TO DISCONNECT THE BATTERY PACK FROM THE ELB 500 TTL UNIT:
1. Place the ELB 500 TTL pack on a flat, dry and clean surface.
2. Press the locking buttons on both sides and lift the unit as
shown in the picture below.

CHARGING INSTRUCTIONS

ELB 500 LI-ION CHARGER (19277)
• Connect the ELB 500 Charger (19277) first to the Li-Ion
battery and then to the mains.
• Charge progress is displayed by a flashing green LED.
• The constant green LED indicates that the battery is
completely charged.
• The ELB 500 Battery charges in approximately 100 minutes.
EN
25