Checking That The Finger Guard Moves Easily; Connecting The Water To The Appliance - Gaggenau RY 491 Instrucciones De Instalación

13. Checking that the finger guard
moves easily
It is now essential to check that the finger guard moves
easily. At a later time any required corrections will be more
difficult.
Note:
The finger guard must be shortened to the required length on
account of the different installation positions.
On both doors of the refrigerator compartment:

Shorten finger guard on the upper side 55 mm above
the cover strip (1.).

Push the cut remnant on the hinge side into the gap
between the appliance and cavity wall.
It must be possible to push in and pull out the part
easily (2.)!
Check ease of movement over the entire height of the
door (3.).
14. Connecting the water to the
appliance
m
CAUTION
When bending the water pipe, do not kink it,
otherwise there is a risk of leaks and water damage.
NOTE
When connecting the water pipe to the solenoid valve
of the appliance, follow the instructions supplied by
the manufacturer of the ice maker installation kit
enclosed with the installation manual.

Remove the cap from the appliance connection (1.).

Bend the water pipe according to the location of the
connection on the appliance (2.).

Push the union nut and seal onto the water pipe.

Push the end of the water pipe into the appliance
connection and screw on the union nut (3.).
Tighten hand-tight.

Using the open-ended wrench, tighten the union nut.
Do not overturn!

Open the shut-off valve and main water tap.

Check the connection on the shut-off valve and on the
appliance for leaks.
m
23