Centrometal CentroPelet ZV16 Instrucciones Técnicas página 55

Do not use abrasive materials or
harsh. Clean with damp cotton or
paper towels.
Check every 7 days
Clean bottom ash from the fallen debris during
operation. You can access the ash pan by loos-
ening the two wing nuts that hold the drawer
inspection. Remove the tray, empty and clean
the wall and only the corners with a suction de-
vice or with dedicated
drawer and tighten the two knobs being careful
to restore the tightness, very important during
operation.
Check every 60/90 days
Internal turbulator compartment cleaning /
Smoke fan compartment
Remove the right side of the stove. It is now
possible to see the air intake hose. At the bot-
tom there is a plate; remove this plate to have
access to the smoke chamber. With a vacuum
cleaner, remove the residues that are in the
smoke chamber and carefully clean the part on
your left that accesses the end of the exchanger
with vertical tube.
tooling. Then mount the
Cleaning Flame beater
The thermostove is provided with two elements in
vermiculite: the bottom of the combustion cham-
ber and the battifiamma.
Vermiculite is a mineral from a variety of uses in
industry and construction for its insulating prop-
erties, thermal and acoustic properties. In this
case, the vermiculite is used to avoid unneces-
sary heat dispersions. Because of its fragility, it
is recommended to handle with extreme care
battifiamma during the cleaning of the combus-
tion chamber and clean it only with a soft, dry
cloth.
Shutting the thermostove down
In the period when the thermostove is out of
use it must be disconnected from the electricity
mains. For greater safety, especially if there are
children around, we recommend removing the
power cable from the rear of the thermostove.
Before placing the thermostove in storage, you
should remove all pellets from the hopper with
a vacuum cleaner with a long extension. If the
fuel is left in the hopper, it may get damp, stick
together, and be difficult to light at the beginning
of the next season.
If pressing the main switch (located on the back
of the stove) does not make the control panel
display light up, it could mean that the service
fuse needs replacing.
On the rear of the stove there is a fuse holding
compartment which is located underneath the
supply socket. With a screwdriver open the cov-
55