Centrometal CentroPelet ZV16 Instrucciones Técnicas página 57

In case of failure or inadequate cleaning of
the heater may have function problems such
as:
• poor combustion
• blackening of the glass
• clogging of grate with accumulation of ash
and pellets
• ash deposit and excessive deposits on the
heat exchanger resulting in poor performance.
The check of electromechanical
components must be performed only
by qualified personnel with technical
knowledge of electricity and combustion.
We recommend that an annual maintenance
service is carried out, preferably under a
programmed service contract. The essential part
of this service is a visual and functional check on
the following components:
• reduction motor
• smoke expulsion fan
• smoke sensor
• heat-exchanger fan
• ignition sparkplug
• resettable pellet thermostat
• room temperature sensor
• pressostat
• motherboard
• fuse protecting panel - motherboard
These operations
performed
technician, or the user who will
take responsibility in the event of
damage during maintenance.
Perform this maintenance heater cold
and in the absence of electricity. If such
maintenance is performed by an authorized
service center is the responsibility of the
customer.
Surface cleaning
The thermostove is a product by heating,
presents the external surfaces particularly hot.
For this reason, we recommend extreme caution
when operating in particular:
• Do not touch the thermostove body and the
various components, do not approach the door, it
could cause burns;
• Do not touch the exhaust fumes;
must be
by a qualified
• Do not perform any type of cleaning;
• Do not dump the ashes;
• Do not open the ash tray;
• Be careful that children do not come close.
All cleaning of all parts must be carried out with
the stove completely cold and the plug discon-
nected.
To clean the surfaces, use a rag dampened
with water or with water and a neutral
detergent.
The use of aggressive detergents or
thinners can damage the surfaces
of the thermostove. Before using
any detergent it is advisable to try
it on a small section out of sight or contact
the Authorized Assistance Centre for
information regarding the product.
Warnings for cleaning
All cleaning of all parts must be carried out with
the stove completely cold and the plug discon-
nected.
Before effecting any maintenance operation or
cleaning on the stove, take the following precau-
tions:
• be sure that all parts of the stove are cold
• be sure that the ashes are completely cold;
• be sure that the general switch is in the "OFF"
position;
• be sure that the plug is pulled out of the socket
to avoid accidental contact;
• Once the maintenance phase is completed
check that
everything is in order as per before the interven-
tion (the
brazier is placed correctly).
Any kind of tampering or unauthorized substitu-
tion of non-original of the thermostove can be
hazardous to the safety of the operator and re-
lieves the manufacturer from any civil or criminal
liability. Use only original spare parts. Replace a
worn before failure promotes the prevention of
injuries resulting from accidents caused by the
sudden failure of the components.
57