Cebora SOUND AC-DC 2330/M Manual De Instrucciones página 13

AW AV AX G
H
I
AT
E
P
AO
Q
R
AA
AL
S
BD
BA
BD) Fitting (1/4 gas)
Used to connect TIG welding torch gas hose .
BE) Main switch.
BG) Power cable
BH) Gas supply fitting .
BO) Connector Type DB9 (RS 232). To be used for
updating the microprocessor programs.
BQ) Power supply socket.
BR) Pressure switch socket.
3.3 PANEL DESCRIPTION (fig. 1).
AT process key.
·Selection is shown by one of the glowing LEDs
AX, AV, or AW.
Led AX Led AV
Mode button E.
Selection is shown by one of the glowing LEDs F,
G, H, I, L, M, N, or PP.
The TIG LEDs lighted will be two at any time, one
showing the HF or contact start-up mode and the other
showing the continuous or pulsed mode with 2 or 4 sta-
F M L U N
Led AW
AQ PP
Y
O
T
BO
W
X
V
AE
BC
BB
BR
Fig. 1
ges control. Every time this push-button is pressed a new
selection is obtained. The LEDs glowing against the con-
cerned symbols show your selection.
thout high frequency.
To light the arc press the welding torch button and with
the tungsten electrode touch the workpiece and then
take it up. The stroke must be firm and rapid (0.3 sec).
high frequency.
Press the torch trigger and a high voltage/frequency pilot
spark will light the arc.
(manual).
When the torch trigger is pressed, the current begins to
increase over the previously set "slope up" time, until it
reaches the value set by means of the knob AA. When
the trigger is released the current starts to decrease over
the previously set "slope down" time and returns to zero.
In this position the pedal control accessory ART. 193 can
be connected.
(automatic).
BG BE BQ
F - LED. TIG welding with arc start-up wi-
L - LED. TIG welding with arc start-up with
G - LED. TIG 2 stages continuous welding
H - LED. TIG 4 stages continuous welding
BH
13