Machine Specifications; Delivery Scope; Intended Use; Ce Declaration Of Conformity - Amann Girrbach Ceramill Therm 3 Manual Del Usuario

M A C H I N E S P E C I F I C A T I O N S
4

Machine Specifications

E N 4.1

Delivery Scope

_ High-temperature furnace Ceramill Therm 3
(178380)
_ Heating rod (4 ×)
_ Exhaust air pipe
_ Floor plate
_ Sintering bowl, stackable
_ Sintering pearls
_ Tongs for sintering bowl
_ Mains cable
_ Allen key
▷ After unpacking, check the machine for com-
pleteness and possible transport damages.
Please claim any transport damages immedi-
ately with your supplier.
4.2

Intended Use

Ceramill Therm 3 is a high-temperature furnace
for the final sintering of dental oxide ceramics,
particularly for Ceramill zirconium oxide blanks.
The sintering furnace is pre-programmed by the
manufacturer with 3 temperature programs,
which are matched to the Ceramill zirconium
oxide frame material.
247 further programming positions are freely pro-
grammable.
The stackable sintering bowl, filled with sintering
pearls, is used for sintering the Ceramill zirconium
oxide frames. Any other or further-going use,
such as the processing of other products than
those intended for, as well as the handling of haz-
ardous substances or materials hazardous to
one's health, does not apply as under the intended
use.
28
As to the materials being used in the furnace, it
must be known whether they are aggressive to or
even could lead to destruction of the insulation or
of the heating rods.
It is prohibited to remove safety devices, bypass
them or put them out of operation.
Unauthorised modifications/alterations of the
machine shall also void the warranty.
The set-up instructions and the safety regulations
must be followed, as otherwise the furnace is con-
sidered as not being used as intended for, and any
and all claims against Amann Girrbach shall
become void.
4.3

CE Declaration of Conformity

This product was designed and manufactured
based on careful selection of the harmonised
standards to be observed, as well as additional
technical specifications. It thus corresponds with
the state-of-the-art and ensures maximum safety.
In terms of design and performance, this product
complies with the European Directives and the
supplementary national requirements. Conform-
ity has been confirmed with the CE marking.
EC Guidelines
2006/95/EC
Applied harmonised standards
DIN EN ISO 12100
DIN EN 61010-1
Tab. 1
The product's Declaration of Conformity can also
be viewed on the manufacturer's website.
2004/108/EC
DIN EN ISO 13732-1
DIN EN 61000-6-1,
DIN EN 61000-6-3